Midi Parameters; Edit Midi Channel; Edit Midi Bank And Program; Edit Midi Volume - Kurzweil KME61 - REV A User Manual

Setup Mode

MIDI Parameters

The remaining parameters are for use with an external MIDI device connected to the MIDI
Out jack. Their values will have no effect on the KME61ʹs internal sounds.

Edit MIDI Channel

Z1:Edit MIDI Channel
This screen allows you to set the MIDI channel each zone uses to send notes and controllers
to external devices. "None" means that the zone does not send any MIDI messages.

Edit MIDI Bank and Program

Z1:Edit MIDI program
►Bnk: 0
These parameters allow sending a program and bank change for each zone to external MIDI
devices. Each has possible values of "None" and 0-127. If "None" is specified, then no
message of that type will be sent. The messages are sent immediately while editing and
when the setup is selected while playing.

Edit MIDI Volume

Z1:Edit MIDI Volume
Vol: 90
This parameter adjusts the relative volumes of sounds played by external MIDI devices
controlled by the zones. MIDI Volume (Controller #7) messages are sent to accomplish this.
A value of "None" means that no volume message is sent for that zone. The messages are
sent immediately while editing and when the setup is selected while playing.

Saving and Exiting from Editing

To exit the setup editing pages and return to the Setup Base page, press the Setup button. If
any parameter was changed while on the editing pages, the Save Dialog will begin with this
screen:
Save Current Setup?
Yes
At this point only the three soft buttons will be recognized as follows:
Cancel - Return to the previous edit page.
No - Go to the Setup Base page without saving the edited values.
Yes - Continue with the next save dialog screen.
4-6
Ch: 1
Pg: 35
No Cancel
Z1:Edit MIDI program
Bnk: 0 ►Pg: 35