Midi Mode Edit Pages; Edit Midi Effect Type; Edit Midi Effect Levels; Edit Midi Channel Enables - Kurzweil KME61 - REV A User Manual

MIDI Mode

MIDI Mode Edit Pages

There are 3 MIDI Mode Edit Pages. An edit page is entered by pressing the MIDI button,
which then begins to flash. The up and down menu buttons cycle among the edit pages.
Pressing the MIDI button again exits back to the last displayed MIDI Mode base page.
Note that Effect Type and Effect Levels set in MIDI Mode only apply to MIDI Mode.
However the Channel Enables also apply to Program Mode as well as MIDI Mode. Selecting
Program or Setup modes resets the effects as specified in the new modeʹs parameters. The
MIDI Mode settings are remembered however and become effective again when MIDI Mode
is re-entered. They may also be saved.

Edit MIDI Effect Type

MIDI Effect Type
14 Stage:Chorus
This page permits the Effect Type for the internal sound generator to be set. The editing
logic is the same as the corresponding screen in Program Mode. See the Appendix for a list
of the 30 available effect types.

Edit MIDI Effect Levels

MIDI Effect Levels
Ch:14 A: 99% B: 28%
This page permits the wet/dry mix for the A and B effects to be set in the internal sound
generator. The levels for each incoming MIDI channel may be set separately.
The left soft button allows a MIDI channel to be selected for level editing. The existing mix
levels for that channel are then displayed. The center and right soft buttons can then be
used to select a level for editing with the + and - buttons and the data slider.
Note that the Effects Type and Effects Levels may be changed from a sequencer via MIDI.
Any MIDI channel that is enabled (see below) may be used. See the MIDI Implementation
chart in the appendix for the controller numbers used to change effects settings.

Edit MIDI Channel Enables

MIDI Channel Enables
Ch:14
This screen allows some of the MIDI channels in the internal sound generator to be turned off.
An off channel will not play any notes or respond to any controllers. The left soft button
along with the + and - buttons or data slider selects a channel to examine or change. The
center soft button along with the + and – buttons will toggle the On/Off status of the channel.
5-2
On