Short Term Storage - Fluke RPM4-AD Operation And Maintenance Manual

The value indicated should be near zero. It is normal for RPM4-AD to indicate a
value other than zero when vented when gauge mode is first entered or the
range is changed. Press [AutoZ]. This runs AutoZ to zero the Q-RPT reading
(see Section 3.3.9.1). Upon return to the MAIN RUN screen, observe that the
indication of measured pressure has zeroed.
If the display fails to zero properly, RPM4-AD may need repair.
2.5

SHORT TERM STORAGE

The following is recommended for short term storage of RPM4:
Remove pressure from the RPM4-AD TEST ports.
Switch power OFF.
Page 11 © 2005-2007 DH Instruments, a Fluke Company
2. INSTALLATION