2.3.2.2
REAR PANEL
1. 12VDC power supply
connection
2. Remote [ENT] connector
3. IEEE-488 connector
4. COM2 connector
5. COM1 connector
6. Power switch
7. Fuse
2.3.3
POWER CONNECTION
2.3.3.1
85 TO 264 VAC, 50/60 HZ VAC POWER
Check that the RPM4-AD power switch is OFF.
Connect the supplied power cable to the rear panel power module.
Connect the other end of the power cable to an electrical supply of 85 to 264 VAC,
50/60 Hz.
2.3.3.2
BATTERY PACK
Charge the battery pack fully (see Section 3.2.9).
Connect the RPM4-AD 12VDC power connection on the rear panel of the
RPM4-AD to the 12 VDC power connection on the battery/charge pack using
the cable supplied with the pack.
See Section 3.2.9 for additional information on battery/charger pack
operation and maintenance.
8. Electrical power connector
(IEC-320-C13)
9. Fan
10. Product label (bottom of case)
11. TEST (Ps), low Q-RPT
12. TEST (Pt), high Q-RPT
13. ATM port
14. VENT port
Figure 2. Rear panel
Page 7
© 2005-2007 DH Instruments, a Fluke Company
2. INSTALLATION