Audi A4 Owner's Manual page 314

document_0900452a81b1b9de.book Seite 312 Donnerstag, 26. Juli 2007 9:16 09
312 Fuses and bulbs
Applies to vehicles: with halogen main beam headlights
Removing rear light
To change the bulbs, you must remove the rear light.
Removing the light requires a certain degree of practical
skill.
– Check which of the bulbs is defective.
– Open the boot lid.
– Remove the side trim.
– Insert the screwdriver (from the tool kit) through the side
opening in the plastic screw ⇒ fig. 302.
– Turn the screwdriver anti-clockwise to loosen the screw
and then carefully remove the screw.
– Gradually ease the light housing out of the rubber
mountings (positions ⇒ fig. 303
alternately in direction of arrows
use the tool for changing bulbs from your vehicle's
toolkit to carefully apply some pressure between posi-
A
tions and
3
– Unplug the electrical connector.
– Change the defective bulb ⇒ page 313.
Fig. 302 Luggage
Caution
compartment: Loca-
tion of retaining screw
When removing or installing the rear light, take care not to cause
for rear light
any damage.
Removing the rear light in particular can lead to the paintwork or
rear light becoming damaged. This is another reason why we
recommend having the bulbs changed by a qualified workshop.
NEVER use metal tools (e.g. a screwdriver) or sharp or pointed
plastic tools to lever out the rear light - risk of damaging the paint.
Note
Fig. 303 Removing
Make sure you have a soft cloth ready to place under the glass on
rear light from side
the rear light, to avoid any scratches.
panel
A A
and ) by pulling
3 4
A A
and . If necessary
1 2
A ⇒
.
4