Audi A4 Owner's Manual page 291

document_0900452a81b1b9de.book Seite 289 Donnerstag, 26. Juli 2007 9:16 09
– Loosen the wheel bolts ⇒ page 289.
– Raise the car with the jack* ⇒ page 290.
– Take off the wheel with the flat tyre and then put on the
spare wheel* ⇒ page 291.
– Lower the vehicle to the ground.
– Tighten the wheel bolts firmly in diagonal sequence with
the box spanner ⇒ page 289.
– Fit the hub cap back on.
After changing a wheel
What you must do after changing a wheel.
– Place the wheel with the defective tyre in the spare wheel
well and secure it.
– Put the tools and the jack* back in the luggage compart-
ment.
– The inflation pressure of the newly fitted spare tyre must
be checked as soon as possible.
– Have the tightening torque of the wheel bolts checked as
soon as possible with a torque wrench. The correct tight-
ening torque is 120 Nm.
– Have the flat tyre replaced as quickly as possible.
Note
If you notice that the wheel bolts are corroded and difficult to
turn when changing a wheel, they must be replaced before having
the tightening torque checked.
In the interest of safety, drive at moderate speeds until the tight-
ening torque of the wheel bolts has been checked.
Controls
Hub caps
The hub caps must be removed for access to the wheel
bolts.
Removing
– Insert the hook (provided in the vehicle's tool kit) in the
– Pull off the hub cap ⇒ fig. 271.
Loosening and tightening the wheel bolts
The wheel bolts must be loosened before raising the
vehicle.
Safety Driving tips General maintenance
hole in the hub cap.
Self-help
Self-help 289
Fig. 271 Changing a
wheel: Removing a hub
cap
Fig. 272 Changing a
wheel: Loosening
wheel bolts
Technical data