Audi A4 Owner's Manual page 298

document_0900452a81b1b9de.book Seite 296 Donnerstag, 26. Juli 2007 9:16 09
296 Self-help
Do not pull too hard with the towing vehicle and take care to avoid
jerking the towrope. When towing on a loose surface there is always
a risk of overloading and damaging the anchorage points.
Caution
If there is no oil in the gearbox or no lubricant in the automatic
transmission the car may only be towed with the driven wheels
lifted clear of the road, or transported on a special car transporter
or trailer.
Note
Note the regulations concerning towing.
The hazard warning lights of both vehicles must normally be
switched on. However, observe any regulations to the contrary.
Make sure that the towrope is not twisted, as otherwise the front
towline anchorage on your vehicle could work itself loose.
Front towline anchorage
The front towline anchorage is only mounted if the vehicle
has to be towed.
The screw connection for the towline anchorage is located
behind a cover cap on the right side of the front bumper.
– Take the towline anchorage out of the vehicle's tool kit
⇒ page 283.
– To detach the cover cap from the bumper, firmly press
the lower part of the cap inwards to release it ⇒ fig. 280.
– Screw the towline anchorage firmly all the way into the
screw connection ⇒ fig. 281.
After use, unscrew the towline anchorage and put it back in the
toolbox. Replace the cap in the bumper. The towline anchorage
should always be kept in the vehicle.
WARNING
If the towline anchorage is not screwed in as far as the stop, there
is a risk of the screw connection shearing off during towing (acci-
dent risk).
Fig. 280 Front
bumper: Cover cap
Fig. 281 Front
bumper: Fitting the
towing eye