Audi A4 Owner's Manual page 309

document_0900452a81b1b9de.book Seite 307 Donnerstag, 26. Juli 2007 9:16 09
– Take the screwdriver and the interchangeable Torx socket
out of the vehicle tool kit.
– Remove the screws ⇒ page 306, fig. 288 that secure the
trim panel to the lock carrier and detach the trim panel.
– Slacken the two screws that secure the headlight to the
lock carrier and the two screws at the underside of the
headlight (the screws at the underside should not be
slackened more than five turns) ⇒ page 306, fig. 289.
– Carefully pull the headlight forward about 60 mm.
– Release and unplug the electrical connector.
– Carefully take the headlight out towards the front (swivel
it slightly if necessary).
Installing
– Perform all of the above steps in reverse sequence.
The headlight must be inserted in two guides (on the underside of
the headlight). This is the only way to ensure that the headlight is
installed in the correct position. To determine whether the headlight
is correctly installed, check that it is aligned flush with adjacent
body parts (such as the wing panel).
Do not interchange the securing screws.
Caution
Please take particular care not to damage or scratch the adjacent
parts of the body when removing or installing the headlights.
Controls
Removing bulb for main beam headlights
– Remove the headlight ⇒ page 306.
– Take off the rubber cap ⇒ fig. 290 ⇒
– Press the connector in the direction of the arrow
– Remove the connector together with the bulb from the
– Disconnect the connector from the base of the bulb
Safety Driving tips General maintenance
bulbs" on page 304.
⇒ fig. 291.
headlight housing.
⇒
in "Changing bulbs" on page 304.
Self-help
Fuses and bulbs 307
Fig. 290 Headlight
unit: Rubber cap is
highlighted
Fig. 291 Bulb holder
for main beam head-
lights
in "Changing
Technical data