Audi A4 Owner's Manual page 138

document_0900452a81b1b9de.book Seite 136 Donnerstag, 26. Juli 2007 9:16 09
136 adaptive cruise control (ACC)
Vehicle in front: If a vehicle is detected in front, the arrows will be
on the scale. The green area of the scale represents the distance
setting. If you approach the vehicle in front slowly, the arrows will
move from the grey area into the green area of the scale.
Driver intervention prompt: If you approach the vehicle in front
quickly, the arrows act as a warning. When the actual distance is
shorter (or is likely to become shorter) than the distance selected,
the arrows move into the red area of the scale. In certain situations,
you may need to intervene as the driver ⇒ page 138, "Driver inter-
vention prompt".
A
Status
C
ACC OFF (in white letters): The adaptive cruise control is
switched off.
ACC AVAILABLE (in white letters): The system is switched on but
the control has not yet been activated.
OVERRIDE (in white letters): You have exceeded the target speed
by accelerating.
DISTANCE! (in red letters): The distance to the vehicle in front is
not sufficient and you have to brake the vehicle with the foot brake.
DISTANCE 1 to DISTANCE 4 (in green letters): Shows the time
interval you have selected. The adaptive cruise control is in cruise
mode.
DISTANCE 1 - dyn., DISTANCE 1 - comf.
the settings are adjusted on the sound system or MMI* such that
the "standard" driving program is replaced by "comfort" or
"dynamic", the message above will indicate the setting.
Applies to vehicles: with adaptive cruise control
System status indicator in the instrument
cluster display
The text messages and symbols in this section of the
display are not shown permanently.
Time intervals (e.g.
The various symbols for the time intervals -arrow- ⇒ fig. 146 appear
when you change the settings.

The symbol
off.
etc. (in green letters): If
...
The text message ... (three white dots) appears if a setting made
with the control lever cannot be implemented. There can be several
reasons for this:
You have pulled the control lever towards you to resume the
programmed cruising speed, without a target speed having been
set.
The control lever has been pushed up / down to increase / reduce
the speed, without a target speed having been set.
Fig. 146 Instrument
cluster: Further infor-
mation

)

indicates that the warning tone has been switched