Audi A4 Owner's Manual page 129

document_0900452a81b1b9de.book Seite 127 Donnerstag, 26. Juli 2007 9:16 09
be deactivated temporarily. The green symbol in the display will
change to white but the stored speed will be retained.
Applies to vehicles: with cruise control system
Pre-selecting a speed
You can pre-select a desired speed while the vehicle is
stationary.
– Switch on the ignition.
A to position 1 ⇒ page 125, fig. 134.
– Pull the lever
A
A
– Push the lever up towards
order to increase or reduce the cruising speed setting.
– Release the lever to store the cruising speed setting
displayed.
This function allows you to enter the desired cruise control setting
speed ahead of time, for example before joining a motorway. Once
you are on the motorway, you can activate the cruise control system
A
by pulling the lever to position .
1
Applies to vehicles: with cruise control system
Switching off the cruise control system
Switching off temporarily
– Press the brake pedal, or
– Manual gearbox: Press the clutch pedal for a relatively
long period, or
A A
– Push lever to position
A 2
⇒ page 125, fig. 134, or
Controls
– Drive more than 10 km/h faster than the stored speed
Switching off completely
– Press the lever
– Switch off the ignition.
The speed setting will remain stored after the system is temporarily
deactivated. To resume the programmed cruising speed, release the
clutch or brake pedal and pull the lever to position
The stored speed will be deleted once the ignition is switched off.
A
or down towards in
+ -
Do not resume the programmed cruising speed if this is too high
for the traffic conditions - this can cause accidents.
(click stop not engaged)
Safety Driving tips General maintenance
over a period of more than 5 minutes.
A A
to position (click stop engaged), or
A 2
WARNING
Self-help
Driving 127
A
.
1
Technical data