Table of Contents
Advertisement
If no dust collector is connected saw dust and
chips build up inside the chip case. These
need to be removed after latest 30 minutes of
operation.
Dust collection ports are provided on the saw blade
guard and the chip case.
Suction hose for chip case
1. Turn saw upside down.
2. Remove transport support inside the saw hous-
ing.
3. Attach suction port to chipcase with
- 3 ea. hex. head screw M 6x13
- 3 ea. washer
- 3 ea. serrated lock washer
- 3 ea. hexagon nut M 6
4. Attach the 100 mm diameter suction hose and
secure in place with the hose clamp supplied.
Suction hose for blade guard
1. Fit blade guard to riving knife.
The lower edge of the blade guard should be in
a horizontal position.
2. Attach the small diameter suction hose to the
blade guard.
3. Hook hose carrier into horizontal slot of the saw
housing's right-hand side panel.
4. Attach small diameter suction hose to hose car-
rier.
PKF 255 V8
5. Attach the ends of both suction hoses to the
suction connector.
A
Caution! The opening for the small suction
hose inside the suction connector must face
away from the saw.
6. Install suction connector near the saw.
7. Connect a suitable dust collector to the suction
connector.
Workstand
This saw needs to be mounted on a sturdy work-
stand.
Within the workstand sufficient space for the suction
hose must be available.
Installation of the travelling sizing table
The travelling sizing table is available in two lengths:
· 950 mm table length
(with four long screws for installation to the saw)
· 1800 mm table length
(with eight screws: four long ones for fitting to
the saw, and four short ones for attaching the
support leg).
3
For installation of the travelling sizing table
two persons are necessary.
1. Place travelling sizing table on a level surface,
with the threaded ends of the screws showing
upwards.
2.7
Hide quick links:
Advertisement
Table of Contents
