Elektra Beckum PKF 255 V8 Operating Instruction page 15

Main saw blade adjustment
The saw blade must run exactly parallel with the
saw table's edge. The distance between the table's
edge and the blade shall be not more than 3 mm.
Adjustment is done from the top with setting nuts.
This setting is then fixed by two counter nuts on the
underside of the saw:
1. Remove travelling sizing table.
2. Loosen screws on chip case cover. Lift chip
case cover slightly and swing over the screws.
The cover is hooked into the bottom of the chip
case and can not fall down.
3. Tighten two each setting nuts on the swivel seg-
ments against each other.
3
The swivel segments' setting nuts must not
be tightened during operation of the saw ,
as this would create mechanical twisting and
warping.
4. Turn saw over and place on its saw table.
5. Loosen the two nuts inside the saw by approx.
one turn.
6. Stand saw back on its feet/workstand.
7. Adjust saw blade position by turning the setting
nuts.
8. Turn saw over again and place on its saw table.
PKF 255 V8
9. Tighten both nuts inside the saw again.
10. Stand saw on its feet/workstand again.
11. Loosen all setting nuts by approx. two turns.
12. Slide chip case cover back into the closed posi-
tion and tighten screws.
13. Mount travelling sizing table.
Scribing blade change
A
Danger!
Risk of injury by the saw blade's teeth. Wear
gloves when changing blades.
1. Dismount the main saw blade (see „Main saw
blade change").
2. The scribing blade's drive belt is tensioned by a
spring, which pushes the scribing blade drive
motor down. To take the drive belt off, lift motor
up.
3. Lock scribing blade with open-end spanner and
loosen the arbor nut (standard R.H. thread).
4. Remove scribing blade and dish spring assem-
bly from blade arbor.
2.13