Table of Contents
Advertisement
· To lock, return travelling sizing table to its rest
position, then turn travel lock lever by 90˚ and let
engage in borehole.
Hold-down plate
The hold-down plate is fitted into the fitting hole pro-
vided on the travelling sizing table.
The hold-down plate firmly holds long stock on the
travelling sizing table during cutting. This is espe-
cially useful for trimming cuts.
Rip fence
The rip fence slides onto the saw from the right-
hand side and locks on the saw's front.
3
For locking always tighten the lower lock
lever, to prevent jamming.
The auxiliary fence extrusion can be repositioned
after loosening the two wing nuts:
· small edge (as shown):
- for cutting thin stock;
- when the saw blade is tilted.
2.6
· wide edge:
- for cutting thick stock
(max. 65 mm).
Mitre fence
The mitre fence is pushed into the groove of the
travelling sizing table and locked in position with the
lock lever (black arrow).
For mitre cuts the fence extrusion turns through 45˚
in both directions. To set a mitre angle loosen lock
lever (grey arrow).
Assembly and connection
Connection to dust collector
A
Danger!
Some kinds of wooden dust (e.g. from oak
and ash) can be carcinogenic when inhaled.
When working indoors always connect to a suit-
able dust collector (air speed at suction port of
saw ³ 20 m/s).
A
Caution! Operation without a dust collector is
only possible
- outdoors;
- for
a
short
30 minutes);
- with a dust mask.
45
duration
(up
to
max.
PKF 255 V8
Hide quick links:
Advertisement
Table of Contents
