Elektra Beckum PKF 255 V8 Operating Instruction page 10

2. Screw a plastic butterfly nut with a washer a few
turns on each of the long screws.
3. Adjust the position of the screws with attached
butterfly nuts so that they are at a distance
slightly larger than the length of the saw.
4. Turn travelling sizing table over with the help of
another person and place it on the two angle
brackets (black arrows) of the saw.
Do not yet release the travelling sizing table !
5. Slide butterfly nuts towards the saw, into the
slots of the angle brackets (the washers must be
between angle bracket and butterfly nut).
6. Adjust travelling sizing table position:
- travelling sizing table 950 fully to the saw's
front;
- travelling sizing table 1800 only so much, that
it projects between 500 mm and 800 mm
over the saw's front.
7. Tighten butterfly nuts.
2.8
8. Attach support leg to underside of travelling siz-
ing table 1800.
1.
Adjust height of the support leg with its adjusta-
ble foot.
Mitre fence
1. Screw long stud screw into centre tapped hole
of the guide bar and tighten.
2. Screw short stud screw into tapped hole of the
guide bar.
3. Place angle plate on stud screws (short stud
screw into oblong hole).
4. Fit spacer bushing and washer to long stud
screw and screw on the ratchet lock lever.
5. Put large washer on short stud screw and screw
on ratchet lock lever.
6. Fit two cup square neck screws into the fence
extrusion's groove and put the screw's threaded
ends though the oblong holes.
2. 3.
45
PKF 255 V8