Table of Contents
Advertisement
3. Adjust backstop setting screws on both front
and rear of the saw until blade is in exact 0˚ posi-
tion when set against the 0˚ stop.
4. To check the setting of the 45˚ backstop, repeat
steps 1 to 3 accordingly.
5. After resetting any of the backstops, check
bevel tilt scale on the machine's front, adjust if
necessary.
Scale setting
The rip fence scale needs to be set according to the
position and thickness of the saw blade.
1. Position rip fence against the right hand side of
the main blade and lock.
The "0"-mark of the scale should now be directly
underneath the left-hand edge of the rip fence
extrusion. If not:
- loosen fixing screw and reposition scale.
- tighten fixing screw and remove rip fence.
PKF 255 V8
Universal fence adjustments
1. Check if fence is square against saw blade with
a try square.
2. If necessary, loosen fixing screws and adjust
mitre scale.
3. Retighten fixing screws.
Cleaning the saw
1. Lay machine on its side.
2. Remove chips and saw dust with vacuum
cleaner or brush:
- from saw blade setting guide elements
- from travelling sizing table guide elements
- from motor vent slots
Machine transportation
· Lower saw blade completely.
· Engage the travelling sizing table's travel lock.
· Dismount any add-on parts, projecting over the
saw.
· Carry saw with two persons; hold at saw table.
· If possible, pack in the original carton for ship-
ping.
Machine storage
A
Danger!
Store machine so that
- it can not be started by unauthorized per-
sons, and
- nobody can get injured.
3
The on/off buttons can be blocked with a pad-
lock.
A
Caution! Do not store machine outdoors or in
damp environment without protection.
45
2.17
Hide quick links:
Advertisement
Table of Contents
