Product Information; Specifications - AMX PRO-DP16 DECOR PROLINK FLUSH MOUNT KEYPAD PANEL Instruction Manual

Product Information

The PRO-DP16 is a 16-button wall panel designed to directly control AMX Radia Lighting™
systems. It is a PROlink panel that gets its power and data from a Radia Lighting Controller
attached to the dimmer control cards. PROlink panels do not have addresses and can be chained
together with minimal setup requirements. Each wall panel provides individual control of up to 60
channels (zones) via up to 10 dimmer control cards connected via the PROlink bus.
The Decor style PRO-DP16 can store/recall Preset light levels, raise/lower light levels to create
scenes, ramp presets, set dimmer curves and low-end settings, and turn lights on/off. It fits in a 2-
gang wall box and is connected using a low-voltage 4-wire PROlink cable. PROlink panels are
connected directly to the dimmer controllers and work independently from AXlink or AMX
Central Controllers. It comes with a standard overlay that can be custom engraved for special uses,
and allows the removal of selected buttons if desired. The ability to recall different Presets from
different panels is done via rear panel DIP switch settings.

Specifications

Specifications
Dimensions (HWD)
Voltage
Weight
Connector
Front Panel Components:
Pushbuttons
LEDs
Overlay
Rear Panel Components:
DIP switch
PROlink LED
PROlink bus connector
Wiring
Color Availability
Mounting Options
PRO-DP16 Decor 16-Button PROlink Wall Panel
4.68" x 4.75" x 1.72" (11.87 cm x 12.05 cm x 4.36 cm)
12 VDC; 85 mA maximum per panel
3.78 oz. (107.16 g)
PROlink 4-pin data/power captive-wire
Up to 16 gray rubber pushbuttons in a 4 x 4 matrix
• One per button (16 total)
• 6 Channel indicators
• Program Mode indicator (PGM)
• Pack Mode indicator (PCK)
• Curve Mode indicator (CRV)
• Low-End Mode indicator (LE)
Custom engraved; default is blank.
8-position DIP switch that sets the Preset Offset values, Preset/Zone selection,
and programming features. Default = all off.
Green PROlink status LED indicates PROlink power/data status as follows:
• One blink every two seconds indicates power is active and PROlink
communication is working.
• Full On indicates power is active and PROlink communication is not functioning
properly.
If the PROlink LED remains On, check the connections or refer to
the Troubleshooting section on page 12.
Connects to a Radia dimmer Pack using a PROlink cable.
4-conductor, AWG #18 @1,000 feet (304.8 m) max. wire length
White or black panel with gray pushbuttons
• Wall mount fits into most standard US wallboxes
• Podium mount
Product Information
1