AMX COLOR ACTIVE VIDEO TOUCH PANEL (G3 FIRMWARE) Instruction Manual page 7

Specifications AXD-CV6 (Cont.)
Rear Connectors:
AXlink
PWR
RS-232
Video
Character Support:
Compatibility:
Operating
Environment:
Installation Kit:
Enclosure:
Installation Cutout:
Optional
Accessories:
The CV6T is designed to be used on any flat/level surface. The AC-CV6T (FIG. 2) is a metallic
tabletop enclosure that encases the CV6 touch panel and allows its use on a wide variety of
horizontal surfaces.
FIG. 2 AC-CV6T Tabletop Enclosure views (CV6 unit within an AC-CV6T enclosure)
6" Color Video Touch Panels
4-pin bus connector for connection to the AMX Central Controller.
+12 VDC power supply; power is supplied through the bus or an external PSN power
supply.
DB-9 male connector for data transmission or Microsoft
BNC female connector (NTSC/PAL/SECAM)
®
Unicode character support for far-eastern languages such as Chinese.
• Characters for middle-eastern languages such as Arabic are not supported within
the Unicode fonts because they are bi-directional. Buttons with Unicode fonts can
only be created and edited using TPDesign3 and NetLinx Studio. Refer to the
respective manuals for additional information.
Axcess, NetLinx, and Landmark systems (AXlink is the most common control stan-
dard for this system).
Indoor operation at temperatures between 0
humidity range of 5% to 90% RH (non-condensing).
• 4-pin AXlink data/power connector
• 2-pin PWR connector
• Drywall clip set (2-drywall clamps and 2- #8 (2" long) screws)
• 4-#4-40 machine screws and threaded inserts
• Metal sub-plate and bezel with black or white matte finish
• Detachable magnetic front panel bezel
Cutout Template for the AXD-CV6 is available as drawing number 62-5924-06 and
inserted in the product packaging.
This file provides 1:1 cutout dimensions for the CV6 conduit/wallbox. For
replacement of the cutout, contact your AMX sales representative.
• AC-CV6T Accessory Tabletop (used to mount an AXD panel onto a tabletop
surface
• CB-CV6 Conduit/wallbox (includes flanges for installation to studs during the
construction phase). Conduit/Wallbox should only be mounted to a beam
before a drywall is installed (pre-wall).
• Optional spacers and bezels for international sales
• PSN2.8 Power supply (can be used to power the CV6)
• PSN6.5 Power supply (recommended to power the CV6)
Front view
Product Information
®
mouse control
º º º
C (32 F) to 50 C (122
Mounting blocks (2)
Rear view
Strain relief/cable
insertion location
º
F) and a
3