Installing The Axd Panel Using Expansion Clips (Dry Wall) - AMX COLOR ACTIVE VIDEO TOUCH PANEL (G3 FIRMWARE) Instruction Manual

Installation
FIG. 9 Screw locations for flat surface mounting of the main AXD unit

Installing the AXD panel using Expansion clips (dry wall)

Expansion clips are mounted through the two oval holes located at the sides of the panel. As the
screw is tightened, the clip bends toward the insertion hole and into the wall. This bending creates a
"grip" on the wall by either pressing onto the wall or by securing the drywall between the housing
and the drywall clip.
The most important thing to remember when mounting the AXD is that the outer frame
(Mounting Tabs) must be installed flush against the mounting surface.
1. Remove the magnetically attached Decor faceplate (A in FIG. 10) from the main AXD unit
(B in FIG. 10) by gripping the faceplate and pulling with gentle force.
10
Surface mount screws
are inserted through the
outer holes along the housing.
Four drilled holes correspond
to the four (#4) screws used to
secure the housing to the flat surface.
6" Color Video Touch Panels