AMX COLOR ACTIVE VIDEO TOUCH PANEL (G3 FIRMWARE) Instruction Manual page 15

Install the 2 drywall
clips and screws
(included) into the
A - Decor
faceplate
FIG. 10 Wall Mount panel installation configuration for drywall surfaces
The drywall clip set must be re-ordered from AMX if the drywall clip is bent
accidentally during an installation or removed during a re-installation.
2. Cut out the install surface using the dimensions shown in FIG. 11. Be sure to cut out the two
notches along the side of the CV6 to accommodate the two provided drywall expansion clips.
.12
2.900
FIG. 11 Wall Mount panel installation configuration for plasterboard
3. Thread the incoming AXlink wiring through the cutout in the wall.
4. Disconnect the AXlink connector from the Central Controller and thread the terminal end of
the 4-pin AXlink cable through the circular cutout provided on the wallbox.
6" Color Video Touch Panels
holes
Front view
6.79
(BEZEL)
6.21
5.97
ZERO RADIUS
TYP. ALL CORNERS.
.140 DIA HOLES
(CUTOUT)
CUTOUT
B - Main AXD unit consists of
the touch panel and housing
2.45
[62.2 MM]
2.09
[53.1 MM]
.30 [7.6 MM]
MAX
.28 REF
1.71
5.37
(BEZEL)
5.37
1.00 4.43
[136.5 MM]
.25 TYP
Installation
Flat surface
(can include a
wall, podium, or
other level
surface)
2 notches are
required if the unit
is installed in
drywall using the (2)
provided clips
Side view
4.37
[110.9 MM]
11