Related Manuals for Digitus DA-73122
Summary of Contents for Digitus DA-73122
- Page 1 USB 3.2 Gen1 Fiber Extender, 5 Gbps, 4 Ports: 3x USB-A / 1x USB-C, 300m Quick Installation Guide DA-73122...
-
Page 2: Table Of Contents
Table of content Introduction .............. 3 Technical Features ............. 4 Package content ............4 Specification .............. 5 Wall Mounting ............7 Ports and Interfaces ..........7 Connection Diagram ..........9 Q&A ................ 10 Important Safety Instructions: To prevent electric shock, please ensure that all devices are •... -
Page 3: Introduction
Say goodbye to the limitations of traditional USB cables – With this Digitus USB 3.2 Gen1 extender, you can place your USB devices where you need them without compromising on performance. -
Page 4: Technical Features
2. Technical Features USB extension over 300m: Extends USB signals up to • 300m (via LC multi-mode fiber optic cable) without signal loss. Transmitter unit is supplied with power via the host PC • – No additional power supply unit required Four USB ports: Multifunctional USB hub –... -
Page 5: Specification
1x Power supply unit (DC 12V/2A) 1.5m • 1x Wall mounting material (brackets, screws) • • 1x Earthing screw 1x Quick Installation Guide • 4. Specification Maximum 300m range (via LC multi-mode fiber optic cable) 4x USB 3.2 Gen1 inputs (3x USB-A 3.2 USB ports Gen1, 1x USB-C 3.2 Gen1) Transfer rate... - Page 6 cameras, etc. 1x SFP+ output – STP+ 10G module connection 1x Power supply connection (DC 12V/2A) – External power supply connection 2x Status LED indicator 2x Status power indicator TX: Via source device Power supply RX: DC 12V/2A TX: ≤ 2W Power consumption RX: ≤...
-
Page 7: Wall Mounting
5. Wall Mounting Choose the wall mounting position and attach the mounting ears to the unit according to the diagram. 6. Ports and Interfaces Transmitter (TX) Power Steady on: Powered on Light off: Powered off indicator SFP+ Signal Insert SFP+ 10G optical fiber module input... - Page 8 Light off: Transmitter and the receiver have not established a connection Status Steady on: Optical fiber indicator communication between transmitter and receiver successful USB Host Connect USB 3.0 port of host-PC, 3.0 port compatible with USB 3.2 Gen1 Receiver (RX) Steady on: Powered on Power...
-
Page 9: Connection Diagram
SFP+ Signal Insert SFP+ 10G optical fiber output module interface Connect with USB 3.0 device, such USB 3.0 port as printer, camera, scanner, USB flash drive, etc. 7. Connection Diagram One-to-one connection... - Page 10 Connection Instructions 1. Connect the transmitter to the Host PC via USB cable and connect the USB devices to the receiver via USB cables. 2. Connect each SFP module to the transmitter and receiver unit and connect the transmitter and receiver with an LC fiber optic cable.
- Page 11 Hereby ASSMANN Electronic GmbH declares that the Declaration of Conformity is part of the shipping content. If the Declaration of Conformity is missing, you can request it by post under the below mentioned manufacturer address. info@assmann.com Assmann Electronic GmbH Auf dem Schüffel 3 58513 Lüdenscheid Germany...
Need help?
Do you have a question about the DA-73122 and is the answer not in the manual?
Questions and answers