Installing The Cable-Management Bracket On A Cisco Ubr7200 Series Router In A Workbench Or Tabletop Environment; Cabling; Connecting Port Adapter Cables - Cisco 7246 - uBR Router Hardware Installation Manual

Cabling

Installing the Cable-Management Bracket on a Cisco uBR7200 Series Router in
a Workbench or Tabletop Environment
To install the cable-management bracket on a Cisco uBR7200 series universal broadband router installed
on a workbench or tabletop, complete the following steps:
Locate the threaded holes in the right front side of the chassis.
Step 1
Align the cable-management bracket with the four right front threaded holes in the chassis of the
Step 2
Cisco uBR7246 or Cisco uBR7246VXR. (See
Note The cable-management bracket must be installed on the right side of the Cisco uBR7246 and
Cisco uBR7246VXR chassis when viewed from the front.
Thread four (Cisco uBR7246VXR or Cisco uBR7246) M3 x 6-mm Phillips flathead screws through the
Step 3
bracket and into the chassis. Use a number 2 Phillips screwdriver to tighten the screws.
This completes the steps for installing the cable-management bracket on the Cisco uBR7200 series.
Proceed to the following section,

Cabling

This section provides information on connecting port adapter, cable clock card, cable interface card, and
I/O controller cables to your Cisco uBR7200 series universal broadband router.
Warning This product is not intended to be directly connected to the Cable Distribution System. Additional
regulatory compliance and legal requirements may apply for direct connection to the Cable
Distribution System. This product may connect to the Cable Distribution System ONLY through a device
that is approved for direct connection. Statement 1078

Connecting Port Adapter Cables

To avoid electric shock, do not connect safety extra-low voltage (SELV) circuits to telephone-network
Warning
voltage (TNV) circuits. LAN ports contain SELV circuits, and WAN ports contain TNV circuits. Some
LAN and WAN ports both use RJ-45 connectors. Use caution when connecting cables. Statement 1021
The instructions for connecting the cables for each port adapter installed in the Cisco uBR7200 series
universal broadband router are contained in the respective installation document for each port adapter.
For example, if you are connecting the cables for a HSSI port adapter, refer to PA-H HSSI Port Adapter
Installation and Configuration at the following URL:
http://www.cisco.com/en/US/docs/interfaces_modules/port_adapters/install_upgrade/cables_and_atten
uator/hssi_cable_install/HSSIcab.html
Cisco uBR7200 Series Universal Broadband Router Hardware Installation Guide
3-14
Chapter 3
Figure 3-7 on page
"Cabling" section on page
Installing the Cisco uBR7200 Series Router
3-6.)
3-14, to continue the installation.
OL-5421-03