Cisco 7246 - uBR Router Hardware Installation Manual page 149

Chapter 4 Connecting the Cisco uBR7200 Series Router to the Cable Headend
Careful system design and operation can prevent potentially serious intermittent performance problems
across your cable interface network. Each cable operator should make use of the following guidelines
and practices to ensure reliable operation of any 64-QAM based digital network:
"NCTA Recommended Practices for Measurements on Cable Television Systems"
•
(http://www.ncta.com)
Part 76 of the FCC Rules and Regulations (http://www.fcc.gov/mb)
•
DOCSIS 1.0 RF Interface Specification
•
(http://knowledgenet.sciatl.com/DVSPubs/Pdf_DSN/4001000.pdf)
DOCSIS 1.1 RF Interface Specification
•
(http://www.cablelabs.com/specifications/CM-SP-RFIv1.1-C01-050907.pdf)
For example, if your headend overdrives the fiber-optic lasers transmitters, in either the upstream or
downstream path, clipping may occur. Laser clipping leads to degraded signal integrity. In minor doses,
this signal damage is not immediately visible on an analog video signal, but it can completely disrupt
the digital transmission path. (That is, digital signals are more sensitive to clipping than analog signals
and will more readily display the negative effects of laser clipping.)
If a digital signal employing forward error correction (FEC) is near its impairment limit, it is very
susceptible to changes in signal level—on the order of as little as 0.1 dB. If there is no amplitude margin
available in the transmission path between the headend and any one cable modem, the typical signal level
variations of a properly functioning cable system (3 to 6 dB) can create intermittent service outages that
are difficult to isolate.
Typical CATV measurement equipment, such as digital signal level meters, measure to an accuracy of
+/–1 dB. However, some older analog meters only measure to an accuracy of +/–3 dB; therefore,
maintaining 6-dB margins above the minimum levels can provide reliable long-term service.
OL-5421-03
Cisco uBR7200 Series Universal Broadband Router Hardware Installation Guide
Configuring the Digital Signal
4-53