Cisco 7246 - uBR Router Hardware Installation Manual page 71

Chapter 3 Installing the Cisco uBR7200 Series Router
We recommend the rear bracket mounting system for 4-post racks. This method enables you to keep
Note
cables from protruding too far out in front of the Cisco uBR7200 series router and to simultaneously
manage the cables at the front of the chassis with the cable-management bracket.
Figure 3-1
Mounting options are as follows:
If you want the port adapter and cable interface card end (the front) of the chassis recessed in the
•
rack, install the rack-mount brackets at the rear of the chassis in the orientation shown in
on page
• If you want the front of the chassis mounted flush with the front posts of the rack, install the
rack-mount brackets at the front of the chassis in the orientation shown in
If you want the front of the chassis protruding out of the rack, install the rack-mount brackets at the
•
front of the chassis in the orientation shown in
If you want the chassis in a telco-type rack, install the rack-mount brackets in the middle of the
•
chassis in the orientation shown in
OL-5421-03
Typical 4-Post Equipment Rack Posts and Mounting Strips
18.31 in.
(46.48 cm)
hole
center-to-center
Mounting strips
17.5 in.
(44.45 cm)
min.
3-4.
Cisco uBR7200 Series Universal Broadband Router Hardware Installation Guide
Cisco uBR7200 Series Chassis Rack-Mounting Options
Rack posts
110 VAC
outlets
Figure 3-4 on page
Figure 3-5 on page 3-5.
Figure 3-2
Figure 3-3 on page
3-5.
3-3
3-4.