Installing The Brackets On The Chassis; Installing Rack-Mount Brackets On The Rear Of The Chassis - Cisco 7246 - uBR Router Hardware Installation Manual

Chapter 3 Installing the Cisco uBR7200 Series Router

Installing the Brackets on the Chassis

This section explains how to install the rack-mount brackets and cable-management brackets on a
Cisco uBR7200 series universal broadband router. Before installing the chassis in the rack, you must
install a rack-mount bracket on each side of the front, middle, or rear of the chassis. If you are
rack-mounting the Cisco uBR7246 or Cisco uBR7246VXR chassis from the front, you cannot use the
cable-management bracket.
If you are rack-mounting the Cisco uBR7246 or Cisco uBR7246VXR chassis from the rear or middle of
the chassis, you can install the rack-mount brackets and cable-management bracket separately; however,
both rack-mount brackets and the single cable-management bracket must be installed on the chassis
before the chassis is installed in the rack.
The parts and tools required for installing the rack-mount and cable-management brackets are listed in
the

Installing Rack-Mount Brackets on the Rear of the Chassis

To install the rack-mount brackets and cable-management bracket on the chassis for a rear rack-mount
configuration, complete the following steps:
Locate the threaded holes in the rear sides of the chassis.
Step 1
Align the first rack-mount bracket to the threaded holes in the right side of the chassis. See
Step 2
Figure 3-8
Note There are eight holes in each of the rack-mount brackets for the Cisco uBR7246VXR and
Cisco uBR7246 chassis. You may use either set of four holes to align the bracket to the threaded holes
in the sides of the chassis.
OL-5421-03
"Installation Tools" section on page
Installing the Rack-Mount Brackets on the Rear of the Chassis
Rack-mount
bracket
Cisco uBR7200 Series Universal Broadband Router Hardware Installation Guide
2-8.

Installing the Brackets on the Chassis

Figure 3-8.
3-7