Chapter 3
Installing the Cisco uBR7200 Series Router
Connecting Cisco Cable Clock Card Cables (Cisco uBR7246VXR Only)
The instructions for connecting the cables for the Cisco cable clock card installed in the
Cisco uBR7246VXR are contained in the cable clock card installation document.
Refer to Cisco Cable Clock Card Hardware Installation at the following URL:
http://www.cisco.com/en/US/docs/interfaces_modules/cable/clock_card/installation/guide/clk_card.html
Connecting Cable Interface Line Card Cables
The instructions for connecting the cables for each cable interface card installed in the Cisco uBR7200
series universal broadband router are contained in the cable interface card installation document. Refer
to the Cisco uBR7200 Series Interface Line Card Hardware Installation at the following URL:
http://www.cisco.com/en/US/docs/interfaces_modules/cable/line_cards/installation/guide/mcxxfru.html
Connecting I/O Controller Cables
Warning
To avoid electric shock, do not connect safety extra-low voltage (SELV) circuits to telephone-network
voltage (TNV) circuits. LAN ports contain SELV circuits, and WAN ports contain TNV circuits. Some
LAN and WAN ports both use RJ-45 connectors. Use caution when connecting cables. Statement 1021
The console and auxiliary ports for the Cisco uBR7200 series universal broadband router are located on
the I/O controller. The I/O controller also has an optional Fast Ethernet port with a media-independent
interface (MII) receptacle and an RJ-45 receptacle. (See
equipment and pinout information for the console, auxiliary, and Fast Ethernet ports on the I/O
controller.
OL-5421-03
Cisco uBR7200 Series Universal Broadband Router Hardware Installation Guide
Figure
3-12.) This section contains connection
Cabling
3-15