Mode; Measuring The Downstream Rf Signal At The Upconverter Output Using Catv Mode - Cisco 7246 - uBR Router Hardware Installation Manual

Measuring the Downstream RF Signal
Figure 4-28
The approximate in-channel peak-to-valley flatness can be verified using the spectrum analyzer's video
Note
averaging feature. Be aware, however, that values registered while in the video averaging mode are
typically around 2.5 dB below the actual channel power.
Proceed to the next section,
CATV

Measuring the Downstream RF Signal at the Upconverter Output Using CATV Mode

Disconnect the spectrum analyzer from the cable interface card downstream connector.
Step 1
Connect the downstream output of the cable interface card to the upconverter input connector.
Step 2
Connect the spectrum analyzer to the RF output of the upconverter.
Step 3
Set the upconverter output level to the manufacturer's recommended settings. Typical output amplitudes
Step 4
range from +50 to +58 dBmV, although DOCSIS specifies levels as high as +61 dBmV.
Set the spectrum analyzer to view the RF signal at the center frequency you selected for your headend.
Step 5
In this example, the RF center frequency is 705 MHz.
Set the spectrum analyzer to CATV mode (CATV analyzer option) and select the channel measurement
Step 6
option to view the downstream RF signal. Your spectrum analyzer should display a signal similar to the
one shown in
Note Figure 4-29
analyzer in this mode.
Cisco uBR7200 Series Universal Broadband Router Hardware Installation Guide
4-26
Measuring the IF Signal on a Spectrum Analyzer in CATV Mode—Digital Channel
Power Screen (Video Averaging)
"Measuring the Downstream RF Signal at the Upconverter Output Using

Mode."

Figure 4-24.
shows the first of three screens that will be displayed by an Agilent 8591C when you use the
Figure 4-30
Chapter 4 Connecting the Cisco uBR7200 Series Router to the Cable Headend
is the last of the three screens displayed.
OL-5421-03