Installing Rack-Mount Brackets On The Front Of The Chassis - Cisco 7246 - uBR Router Hardware Installation Manual

Installing the Brackets on the Chassis
Thread four M4 x 6-mm Phillips flathead screws through the rack-mount bracket and into the side of the
Step 3
chassis. Use a number 2 Phillips screwdriver to tighten the screws.
Step 4 Repeat
If you plan to include the cable-management bracket in your rear rack-mount configuration, align the
Step 5
bracket with the four right front-side holes.
The cable-management bracket must be installed on the right side of the Cisco uBR7246 and
Note
Cisco uBR7246VXR chassis when viewed from the front.
Thread two four M3 x 6-mm Phillips panhead screws through the cable-management bracket and into
Step 6
the chassis, and tighten the screws.
This completes the procedure for installing the rack-mount brackets and the cable-management bracket
on the chassis for a rear rack-mount configuration. Proceed to the
section on page
Caution To prevent injury, review the safety precautions in
Router for Installation,"

Installing Rack-Mount Brackets on the Front of the Chassis

To install the rack-mount brackets on the chassis for a front rack-mount configuration, complete the
following steps:
If you plan to use the cable-management bracket in your rack-mount configuration for the
Note
Cisco uBR7246 and Cisco uBR7246VXR, you must install your rack-mount brackets on the rear of the
chassis. Proceed to the
Locate the threaded holes in the front sides of the chassis.
Step 1
If you want the front of the chassis flush with the front of the rack, align the first rack-mount bracket to
Step 2
the threaded holes in the right side of the chassis as shown in
If you want the front of the chassis protruding from the rack, align the first rack-mount bracket to the
threaded holes in the right side of the chassis as shown in
There are eight holes in each of the rack-mount brackets for the Cisco uBR7246VXR and
Note
Cisco uBR7246 chassis. You may use either set of four holes to align the bracket to the threaded holes
in the sides of the chassis.
Cisco uBR7200 Series Universal Broadband Router Hardware Installation Guide
3-8
Step 1 through Step 3 for the other rack-mount bracket.
3-11.
before installing the universal broadband router in a rack.
"Installing Rack-Mount Brackets on the Rear of the Chassis" section on page
Chapter 3 Installing the Cisco uBR7200 Series Router
"Installing the Chassis in the Rack"
Chapter 2, "Preparing the Cisco uBR7200 Series
Figure 3-9 on page
Figure 3-10 on page
3-7.
3-9.
3-9.
OL-5421-03