Configuring Port Mirroring; Configuring Routing; Configuring Basic Routing Settings; Configuring Routing Mode - Cisco Small Business RV315W Administration Manual

Networking

Configuring Port Mirroring

Configuring Port Mirroring
STEP 1
STEP 2
STEP 3
STEP 4

Configuring Routing

STEP 1
STEP 2
Cisco RV315W Broadband Wireless VPN Router Administration Guide
Port Mirroring allows traffic on one port to be visible on other ports. This feature is
useful for debugging or traffic monitoring.
To configure port mirroring:
Click Networking > Port Mirroring. The Port Mirroring page opens.
In the Port Mirroring area, click Enable to enable the Port Mirroring feature, or
click Disable to disable this feature.
If Port Mirroring is enabled, enter the following information:
• Mirror Destination Port: Choose the port that monitors the transmitted (TX)
or received (RX) traffic for other ports.
• Mirror Source Port: Check the ports that are monitored. The port that you
set as a TX destination port cannot be selected as a monitored port.
Click Save to save your settings.
This section provides information on configuring the routing mode between WAN
and LAN, viewing the routing table, and configuring the static routing, dynamic
routing, and policy-based routing settings.

Configuring Basic Routing Settings

Depending on the requirements of your ISP, you can configure the RV315W to
operate in NAT mode or Router mode. By default, NAT mode is enabled.

Configuring Routing Mode

To configure the routing mode:
Click Networking > Routing > Basic Routing. The Basic Routing page opens.
In the Routing Mode area, configure the routing mode between WAN and LAN.
5
62