Table of Contents
Advertisement
1
Overview
The Intel
RAID Controller SROMBSASMR) is a high-performance intelligent custom board-to-
board PCI Express* SAS/SATA RAID module that offers reliability, high performance,
and fault-tolerant disk subsystem management. This is a RAID solution that meets the
internal storage needs of workgroup, department, or enterprise systems to use cost-
effective SATA or high performance SAS media.
As a third generation PCI Express* storage controller, the Intel
SROMBSASMR addresses the demand for increased data throughput and scalability
requirements across entry level, midrange, and enterprise server platforms.
The controller can be connected to up to four drives directly and allows the use of
expanders to connect to additional drives. For more information about the use of
expanders, see the ANSI SAS Standard, version 1.0 specification.
SATA and SAS are serial, point-to-point, device interfaces that use simplified cabling,
smaller connectors, lower pin counts, and lower power requirements than parallel SCSI.
The optional Intel
for the RAID module, even during system failures.
Benefits of SAS and SATA
SAS is a serial, point-to-point, enterprise-level device interface that leverages the proven
SCSI protocol set. SAS is a convergence of the advantages of SATA, SCSI, and FC, and is
the future mainstay of the enterprise and high-end workstation storage markets. SAS
offers a higher bandwidth per pin than parallel SCSI and improves signal and data
integrity.
The SAS interface uses the proven SCSI command set to ensure reliable data transfers,
while providing the connectivity and flexibility of point-to-point serial data transfers. The
serial transmission of SCSI commands eliminates clock skew challenges. The SAS
interface provides improved performance, simplified cabling, smaller connectors, lower
pin count, and lower power requirements than parallel SCSI.
SAS controllers leverage a common electrical and physical connection interface that is
compatible with Serial ATA technology. The SAS and SATA protocols use a thin, 7-wire
connector instead of the 68-wire SCSI cable or 40-wire ATA cable. The SAS/SATA
connector and cable are easier to manipulate, connect to smaller devices, and do not
inhibit airflow. The point-to-point SATA architecture eliminates difficulties created by the
legacy ATA master-slave architecture, while maintaining compatibility with existing ATA
firmware.
Intel® Integrated RAID Module SROMBSASMR Hardware User's Guide
®
Integrated RAID Module SROMBSASMR (also known as Intel
®
RAID Smart Battery AXXRSBBU3 provides cached data protection
®
Integrated
®
Integrated RAID Module
1
Advertisement
Table of Contents
