Windows Nt Server Or Workstation - TYAN THUNDERBOLT Manual

driver for you. If you're installing other drivers, Setup displays a README
file with installation instructions. If you can't connect to a server, first try
the suggestions here, then turn to the "Troubleshooting" section on page
44.
• Make sure you're using the drivers for this adapter. The driver filename
contains the letter B (for example, E100BODI.COM).
• If you're replacing an existing adapter, make sure the LINK statement in
your NET.CFG is correct for the new adapter. For example, the LINK
statement for a NetWare client should be: LINK DRIVER E100BODI
• Verify that the frame type in your NET.CFG file matches your network.
• If setting up a server, check your LOAD and BIND statements.
• Test the adapter by running diagnostics in Setup. Additional testing is
available by using a responder (see next page).
• Check the README files.
Responder testing on the network (optional)
Setup can test the adapter more thoroughly if you have a responder on the
network while running the tests.
1. Go to a computer on the network with any EtherExpress adapter installed
(except EtherExpress 32 or EtherExpress 16 MCA).
2. Run the appropriate configuration program for the installed adapter and set
it up as a responder.
3. Return to the computer with the new adapter. Run Setup and make the new
adapter a sender. Test the adapter.

Windows NT Server or Workstation

Automatic configuration
PCI computers automatically detect and configure PCI-compliant adapters
while booting. The Intel 82559-based Integrated Fast Ethernet For WfM
adapter IRQ level and I/O address are automatically set by the BIOS each time
you start your computer. Start your computer to automatically configure the
adapter. Configuration is complete when Windows NT starts or the DOS
prompt appears.
S1837 Thunderbolt
41