Table of Contents
Advertisement
Tomcat i875P S5102
New Windows NT 4.0 Installation
1.
Start the system installation by booting from the Windows NT disk:
a)
Floppy install: boot the system with the Windows NT installation diskettes.
b)
Floppyless install: boot from floppy and type "WINNT /B". After files have been
copied, the system will reboot. On the reboot, press the "F6" key when the
message "Setup is inspecting your computer's hardware configuration..." appears.
c)
CD-ROM disk install: boot from the CD-ROM disk and press the "F6" key when the
message "Setup is inspecting your computer's hardware configuration..." appears.
2.
When the "Windows NT Setup" window is generated, press "S" to Specify an Additional
Device(s).
3.
Press "O" to select "Other" and press the "Enter" key.
4.
Insert the Promise PDC20378 RAID driver diskette into drive A: and press "Enter"
5.
Choose "Win NT Promise FastTrak 378 (or SATA150 TX Series) Controller" from the list
that appears on screen, then press "Enter"
6.
The Windows NT Setup screen will appear again saying "Setup will load support for the
following mass storage devices:" The list will include "Win NT Promise FastTrak 378 (or
SATA150 TX Series) controller".
a)
NOTE: If you need to specify any additional devices to be installed, do so at this
time. Once all devices are specified, continue to step 7.
7.
From the Windows NT Setup screen, press the Enter key. Setup will now load all device
files and then continue the Windows NT installation.
8.
After a successful installation, the "SCSI Adapter Setup" box will show that the "Win NT
Promise FastTrak 378 (or SATA150 TX Series) Controller" driver has been installed.
Existing Windows NT 4.0 Installation
1.
Choose "Settings" from the "Start" menu.
2.
Choose "Control Panel" from the "Settings" menu.
3.
Double-click on the "SCSI Adapters" icon, which generates the "SCSI Adapters" dialog
box.
4.
Choose "Drivers," and then press "Add."
5.
In the "Install Drivers" dialog box, press "Have Disk..."
6.
When the "Install From Disk" appears, insert the "PDC20378 Driver" diskette in drive A:.
7.
Type "A:\NT4" in the text box window, then choose "OK."
8.
When the "Install Driver" dialog box appears, select "Win NT Promise FastTrak 378 (or
SATA150 TX Series) Controller" and then press "OK."
9.
When the "Select SCSI Adapter Option" dialog box appears, press "Install."
10. After a successful installation, the "SCSI Adapter Setup" box will show that the "Win NT
Promise FastTrak 378 (or SATA150 TX Series) Controller" has been installed.
11. Power off your system.
12. If you plan to move the boot drive to connect the PDC20378, now attach the hard drives
otherwise reboot.
Chapter 4: SATA/RAID Setup (for SATA RAID model)
4-8
http://www.tyan.com
Advertisement
Table of Contents
