Connecting Ide And Floppy Drives - TYAN THUNDERBOLT Manual

Table of Contents

Advertisement

5. Connecting IDE and Floppy Drives

The colored stripe on a ribbon cable should face toward the battery on the
motherboard. In Figure 2-24 below, you can see how the IDE cables should
look when they are connected to your hard drive. Notice how Pin 1 (denoted
by a red stripe) is connected so that it is next to the power connector of the
drive. The primary IDE connector is black; the secondary IDE connector is
white.
In most cases, this is the proper way of connecting your IDE cable to the
harddrive. Figure 2-25 on the following page shows the IDE cable properly
connected to the motherboard. Contact your hard disk drive manufacturer or
documentation for more information.
Some symptoms of incorrectly installed HDDs are:
Hard disk drives are not auto-detected: may be a Master / Slave
problem or a bad IDE cable. Contact your vendor.
Hard Disk Drive Fail message at bootup: may be a bad cable or lack
of power going to the drive.
No video or beeps on bootup: usually means the cable is on
backwards.
Hard drive lights are constantly on: bad IDE cable or defective
drives/motherboard. Try another HDD.
Hard drives do not power up: check power cables and cabling.
May also be a bad power supply or IDE drive.
S1837 Thunderbolt
33
Figure 2-24

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

S1837

Table of Contents