TYAN THUNDERBOLT Manual page 30

Chapter 2
Board Installation
Be sure to line up the holes of the retention brace with the screws protruding
from the motherboard. At the same time, make sure the CPU is lined up with
the CPU slot. Lower the three components onto the motherboard. The screws
on the motherboard should fit through the holes of the retention braces and
the CPU should fit into the slot. Secure the retention braces with the nuts
provided in the package. The end result should look like Figure 2-17.
! ! ! ! !
important!
When removing the CPU, unscrew the nuts on the retention braces and
remove all three components at once. This may require careful firm tugs to pull
the CPU out of its slot.
Figure 2-16
Figure 2-17
30
http://www.tyan.com