TYAN THUNDERBOLT Manual page 101

6. Click "Other Location"
7. At the command prompt, type A:\win9X and click "OK". Where A: is the
AIC-7896 driver disk provided by Tyan.
8. Click "Finish"
9. A dialog box "Please insert the disk labeled 7800 family manager set
installation disk" will appear. Click "OK"
10. At the command prompt, type A:\win9x and click "OK"
11. Windows will copy driver from the floppy disk.
12. Repeat the steps above for secondary SCSI channel.
13. Reboot the system when prompted.
Computers with Windows NT Installed
1. Use the three floppy disks that come with Windows NT 4.0 for installation.
2. After the second floppy disk finishes loading, NT will ask for a mass
storage device. At this point, you can have Windows NT install the
Adaptec 7896 driver from the disk provided by Tyan.
3. Follow the NT installation instructions.
Computers with NetWare, OS/2, SCO UNIX, and UnixWare
The 7800 Family Manager Set included in the package allows you to install
drivers for NetWare, OS/2, SCO UNIX, and UnixWare. Refer to the 7800 Family
Manager Set User's Guide for installation instructions.
5. Troubleshooting
If you have any problems during the installations, check the following items
first:
Are all SCSI devices powered on?
Are all SCSI cables and power cables properly connected?
Does each device on the SCSI bus have a unique SCSI ID?
Does the total SCSI cable length exceed the maximum allowable
length?
Is the SCSI chain properly terminated?
S1837 Thunderbolt
101