TYAN THUNDERBOLT Manual page 53

WINNT /ox or WINNT32 /ox command, the following error message may be
displayed:
This floppy disk is not formatted as high-density, not formatted
with a standard Windows NT or MS-DOS format, or is corrupted.
Setup is unable to use this disk.
CAUSE OF THE PROBLEM: You are using a LS/120-type floppy disk drive.
RESOLUTION - To work around this issue, install Windows NT Worksta
tion with the /b switch. This causes Windows NT Workstation Setup to run
without requiring the installation disks.
If you are using the S1837D or are installing with Adaptec 3940 with AIC-
7896 chip then you must install NT 4.0 with a standard 1.44MB floppy disk.
Q: Where can I get Intel PRO/100+ Management Adapter drivers?
A: You will find the drivers located in the Tyan Drivers CD under the
subdirectory 'LAN82559'. Please note: You must use the drivers provided
in the Tyan CD only. These drivers have been tested and approved by
Tyan engineering.
Q: Why does my Intel Ethernet work only intermittently?
A: The Inter Ethernet only operates under standby current; therefore, your
power supply must be ATX 2.01 Compliant with a minimum SB5V current of
750mA.
Q: Why does my keyboard LED remain on after the system is turned off?
A: This situation is most likely caused by the enabling of Keyboard Wake-Up
Function (under the Peripheral Setup) in the BIOS. When enabled, the
motherboard would provide a standby voltage to the keyboard. This would
subsequently cause the LED to remain on.
Q: How do I enable the Keyboard Wake-Up function?
A: You will need go into the BIOS and enable the LAN Wake-Up for Onboard
LAN (under the Power Management Setup) and the Keyboard Wake-Up
Function (under the Peripheral Setup). When both functions are enabled,
you can start up your system by hitting the Ctrl key and the F1 key at the
same time. By default both the LAN Wake-Up and Keyboard Wake-Up
functions are disabled.
S1837 Thunderbolt
53