TYAN THUNDERBOLT Manual page 28

Chapter 2
Board Installation
On both sides of the SECC2 CPU reside the lower tabs of the aluminum heat
sink and the bottom corners of the plastic CPU enclosure (see Figure 2-13).
These tabs and corners should fit into the retention braces.
Warning: DO NOT first screw the retention braces onto the motherboard by
! ! ! ! !
themselves. If you do, you will have difficulties inserting the CPU into the
retention braces and CPU slot.
important!
Pentium II
Figure 2-12
SECC2 Pentium II
Lower Tabs
Enclosure
Corners
Figure 2-13
28
http://www.tyan.com