Related Manuals for NoiseKen ESS-6008
Summarization of Contents
Preface
Preface
Provides a brief introduction to the manual and the electrostatic discharge simulator.
Function of the Unit
Outlines the primary capabilities and testing standards supported by the unit.
Basic Safety Precautions
Symbols of Hazard
Explains hazard symbols like Danger, Warning, and Caution used in the manual.
Danger
Details immediate dangers and prohibitions for unit operation.
Warning
Lists conditions requiring immediate stop and actions to take during operation.
Caution
Provides advice and precautions for safe operation and maintenance.
Appearance of the Unit
Front Panel
Details the controls and indicators on the front of the unit.
Rear Panel
Describes the connectors and labels located on the rear of the unit.
Injection Probe
Explains the Human Body Model (HBM) and Machine Model (MM) injection probes.
Control Panel
Explains the function of each button and display on the unit's control panel.
Block Diagram
Illustrates the internal circuit schematic of the main unit and injection probe.
Connection
Connecting Injection Probe
Guides on how to connect the injection probe to the main unit.
Fixing Injection Probe
Instructions on mounting the injection probe onto a probe stand.
Waveform Adjusting Card
Explains the purpose and types of waveform adjusting cards.
Connecting AC Cord
Details how to properly connect the AC power cord.
Operation
Power ON / OFF
Steps for turning the unit on and off.
Setting Up Test Condition
How to configure test parameters like voltage, interval, and count.
Setting Other Functions
Covers setting Measure, Call, Sweep, and Stage functions for advanced operation.
TRIG OUT
Describes the TTL signal output for discharge timing synchronization.
Finishing Test
Procedures for concluding a test and safety considerations.
Starting Test
Steps to initiate a test and probe aging procedure.
Specifications
Main Unit
Technical specifications for the main unit.
Injection Probe (Common)
General specifications for the injection probes.
Human Body Model (HBM) Injection Probe
Detailed specifications for the HBM injection probe.
Machine Model (MM) Injection Probe
Detailed specifications for the MM injection probe.
Need help?
Do you have a question about the ESS-6008 and is the answer not in the manual?
Questions and answers