Stacking Ax2265P Systems On Flying Bar Kptax2265; Stacking Arrays Of Ax2265P And Ax1115Sp Systems Combined On Flying Bar Kptax2265 - PROEL AXIOM - VERSION 2.0 Manual

5. Guide to System Setup
5.4.1 Stacking AX2265P systems on flying bar KPTAX2265
Choosing the array configuration
The array configuration is limited by the fact that, when stacked, the systems can only maintain partial
angles because only the hole on the slotted bar, and not the slot, can be used to couple them
Flying bar KPTAX2265 used as stacking base
Flying bar KPTAX2265 with its rubber feet can be used to stand AXIOM System Stacked Arrays safely.
As opposed to its conventional use, the bar needs to be mounted upside down on the ground and
perfectly balanced by adjusting the height of its feet. Always verify that the bearing surface is stable and
compacted.
Sequence of mounting operations
• Positioning flying bar KPTAX2265 on the ground put the bar down on the ground in the position
where you will stack the array and adjust the feet so to lie the bar perfectly horizontal. Obviously,
the ground needs to be absolutely stable and compacted.v
• Coupling the first speaker enclosure with KPTAX2265
The first loudspeaker of the array is coupled to the bar following the same procedure described for
the suspension of the array.
Couple the front cams of the flying bar to the front lateral bars on the enclosure and fasten them
with the pin.
Couple the back slotted bar to the flying bar inserting the pin in the hole of the slotted bar and in
the coupling frame of bar KPTAX2265.
• Coupling the next enclosures
You can stack another enclosure on the array lifting it up and placing it upside down on top of the
array. Now you can couple its front cams to the frame of the enclosure underneath and secure
them with the pins. Then lift the back part of the enclosure and set the relative angle using the hole
in the slotted bars on the back and the hole in the frame of the enclosure underneath, and secure
their position with a pin.
Verify that the angle has been set correctly on both slotted bars of the enclosure.
You can now proceed iteratively to complete the assembly of the whole stacked array.
Sequence of disassembly operations
Disassembly works the same way assembly does, simply inverting the order of the operations.
Load limits
With this configuration you can stack up to eight AX2265P.
5.4.2 Stacking arrays of AX2265P and AX1115SP systems combined on flying
bar KPTAX2265
Flying bar KPTAX2265 can also be set on the ground to stack arrays of AX2265P and AX1115SP sys-
tems combined. In this case you can only mount the subwoofers (AX1115SP) under the loudspeakers
(AX2265P), as the angle between the subwoofer/s and the flying bar (therefore the ground) cannot be
changed.
Always verify that the surface bearing the array is stable and compacted.
13
When designing the system, simplicity and practicality in mounting the suspended version prevailed, and we introduced a
slotted bar to diminish the compression stress during the ascent and descent of the system.
5.4. STACKING AX2265P AND AX1115SP SYSTEMS
73
13
.