Stacking Arrays Of Ax3210P And Ax1118Sp Systems Combined On Flying Bar Kptax3210 - PROEL AXIOM - VERSION 2.0 Manual

5.2. STACKING AX3210P AND AX1118SP SYSTEMS
4. Front coupling
5. Setting the angle with the back slotted bar
Verify that the angle has been set correctly on both slotted bars of the enclosure.
You can now proceed iteratively to complete the assembly of the whole stacked array.
• Removing the caster boards
Once you have completed the array you can remove the caster boards and put them away.
Sequence of disassembly operations
Disassembly works the same way assembly does, simply inverting the order of the operations.
Load limits
With this configuration you can stack up to eight AX3210P.
5.2.2 Stacking arrays of AX3210P and AX1118SP systems combined on flying
bar KPTAX3210
Flying bar KPTAX3210 can also be set on the ground to stack arrays of AX3210P and AX1118SP sys-
tems combined. In this case you can only mount the subwoofers (AX1118SP) under the loudspeakers
(AX3210P), as the angle between the subwoofer/s and the flying bar (therefore the ground) cannot be
changed.
Always verify that the surface bearing the array is stable and compacted.
60
5. Guide to System Setup