Table of Contents
Advertisement
AX2265P
AX2265P
• VeCAM Module for high power curvilinear
vertical arrays
• Acoustic Coverage Improvement Device
(A.C.I.D. Technology)
• Integrated suspension system
• Amp Ready format
Description
Model AX2265P is a compact module for under-
dimensioned Vertical Arrays that will surprise you
with its quality and high pressure. AX2265P is
a 2-way bi-amplifiable system designed for live
concerts and permanent installations. It features
two mid-low 6.5" loudspeakers with neodymium
magnet, aluminium coil and single demodulat-
ing ring.
The compression driver features a
neodymium magnet, a 1" throat and is equipped
with a special titanium membrane which enables
it to work well even at 1.3 kHz despite its small
size. The average nominal angular dispersion is
◦
110
(-6 dB) on the horizontal level, whereas the
vertical dispersion depends on the composition
of the array. Each single element, and particu-
larly the high range wave guide, has been stud-
ied to combine at its best with the rest of the
system, especially when the array has a high
curvature. Precise directivity control in the high
range lowers destructive interference phenom-
ena to their minimum. Entirely made of pres-
sure die cast aluminium, the wave guide min-
imises transfer loss whilst maintaining the ef-
ficiency of the driver, especially at band ex-
tremes.
Model AX2265P has been designed
(AMP READY Format) for the installation of on-
board amplifier/digital processor units. The sus-
pension and transportation system is completely
integrated with the exception of the flying bar
KPTAX2265. This bar can suspend up to 24
AX2265P elements with a security factor of 7:1.
Data Sheet
System
System Type
Frequency Response
Nominal Impedance
Continous Power
Peak Power
Coverage Angle H. (-6 dB)
Coverage Angle V. (-6 dB)
Directivity Index (DI)
Maximum Peak Output
Signal Processing
Transducers
Mid Frequency Device
Sensitivity
High Frequency Device
Sensitivity
Mechanical Data
Construction
Flying System
Dimensions (WxHxD)
Engineering specifications
The system should be a two-way passive enclo-
sure, with a frequency response from 125 Hz to
18 kHz and a horizontal coverage of 110
system should have a 4" driver with a coaxial di-
aphragm and a 2" throat fit with a wave guide,
power handling of 150 W AES and an impedance
of 16 Ohms. The system should also have two
10" low frequency loudspeakers with a 3" voice
coil. The system should provide a suspension
mechanism for curvilinear vertical arrays, allow-
ing the adjustment of the angle between each of
the elements. The enclosures must be made
18
2. Specifications
AX2265P
2-way full-range vertical ar-
ray element bi-amp
125 Hz - 18 kHz
8 Ω + 16 Ω
500 W + 80 W AES
1000 W + 160 W
◦
110
average
depending on array size
depending on array size
129 dB @ 1 m
Proel DSO26
Lake Contour Pro 26
2 x 6.5" woofer - 2" voice
coil
99 dB SPL (2.83 V, 1 m)
1" compression driver -
horn loaded
110 dB SPL (4 V, 1 m)
◦
trapezoidal (12
)
15 mm birch plywood
internally reinforced
with paint finish
built in suspension system
58.5 x 19 x 46 cm
Weight
18.5 kg - 40.8 lb
◦
. The
Hide quick links:
Advertisement
Table of Contents
