Flying An Array Of Ax2265P And Ax1115Sp Using Flying Bar Kptax2265 - PROEL AXIOM - VERSION 2.0 Manual

5. Guide to System Setup
10. The array is completely off the ground
• Arranging the position of the array
At this point the array can be lifted to the desired height and fastened with ropes to avoid its rotation
or oscillation due to the wind, especially when you are using only one flying point.
Once the array has been positioned correctly, the flying device has to be checked to assure safety
according to all current local and national regulations.
Sequence of disassembly operations
Disassembly operations are exactly the same described for assembling the array, you need only to
reverse their sequence.
Load limits
ILoad limits have been determined during the design phase by calculations executed through Finite
Element Modeling then validated by empirical load tests.
Flying bar KPTAX2265 can hold up to 24 AX2265P systems.
Figure 5.22 shows some configurations that have been verified; please contact Proel's Technical
Office if you need to verify any other configuration..
5.3.2 Flying an array of AX2265P and AX1115SP using flying bar KPTAX2265
Flying bar KPTAX2265 allows the suspension of systems composed by AX2265P and AX1115SP
Array configuration choice
We discussed the advisability of systems composed with suspended subwoofers in the preceding chap-
ter. The LAC software will simulate the acoustic behaviour of the system, define its barycentre and
determine the mechanical configuration of the system.
12
And obviously of arrays composed only of AX1115SP systems.
5.3. SUSPENDING AX2265P AND AX1115SP SYSTEMS
69
12
.