Table of Contents
Advertisement
AX3210P
AX3210P
• VeCAM Module for high power curvilinear
vertical arrays
• Acoustic Coverage Improvement Device
(A.C.I.D. Technology)
• Integrated suspension and transportation
systems
• Amp Ready format
Description
Model AX3210P is a 3-way, full-range bi-
amplifiable module for vertical arrays designed
for live concerts or for permanent installations.
It features two 10" woofers with ISV (Interleaved
Sandwich Voice) coil, SDR (Single Demodula-
tion Ring) and DDS (Double Silicon Spider).
Its 2-way, coaxial compression driver features a
neodymium magnet and a 2" throat. It mounts
a 4" annular membrane for the reproduction of
mid-range frequencies and a 2" membrane for
high frequencies. The average angular horizon-
◦
tal coverage is 110
dispersion depends on the composition of the
array.
Every single element, and particularly
the high-frequency wave guide, has been stud-
ied to combine at its best with the rest of the
system, especially when marked curvatures are
needed. The precise directivity control in the
high range reduces destructive interference to a
minimum. The wave guide, completely manu-
factured using a special toughened and damped
material, minimizes transfer losses while main-
taining the efficiency of the driver, especially at
band extremes. Model AX3210P is designed
(AMP READY Format) for the installation of on-
board amplifier/digital processor units currently
under development. The suspension and trans-
portation system is completely integrated with
the exception of its basic element, flying bar
KPTAX3210. This bar can suspend up to 24
AX3210P elements with a security factor of 7:1.
(-6 dB), while the vertical
Data Sheet
System
System Type
Frequency Response
Coverage Angle H. (-6 dB)
Coverage Angle V. (-6 dB)
Directivity Index (DI)
Maximum Peak Output
Signal Processing
Transducers
Mid Frequency Device
Nominal Impedance
Power Rating
Sensitivity
High Frequency Device
Nominal Impedance
Power Rating
Sensitivity
Mechanical Data
Construction
Flying System
Dimensions (WxHxD)
Weight With Skate
Engineering specifications
The system should be a two-way passive enclo-
sure, with a frequency response from 75 Hz to
20 kHz and a horizontal coverage of 110
system should have a 4" driver with a coaxial di-
aphragm and a 2" throat fit with a wave guide,
power handling of 150 W AES and an impedance
of 16 Ohms. The system should also have two
10" low frequency loudspeakers with a 3" voice
coil. The system should provide a suspension
10
2. Specifications
AX3210P
3-way full-range vertical
array element - bi-amp
75 Hz - 20 kHz
◦
110
average
depending on array size
depending on array size
131 dB @ 1 m
Proel DSO26
Lake Contour Pro 26
2 x 10" neodymium woofer
- 3" voice coil
8 Ω
800 W AES
1600 W program
99 dB SPL (2.83 V, 1 m)
2"
coaxial
compression
driver - horn loaded
16 Ω
150 W AES
300 W program
110 dB SPL (4 V, 1 m)
◦
trapezoidal (12
)
15 mm birch plywood
internally reinforced
with paint finish
built in suspension system
79.6 x 32.1 x 66.5 cm
Weight
51.5 kg - 113.5 lb
57.5 kg - 126.7 lb
◦
. The
Hide quick links:
Advertisement
Table of Contents
