Stacking Ax3210P And Ax1118Sp Systems; Stacking Ax3210P Systems On Flying Bar Kptax3210 - PROEL AXIOM - VERSION 2.0 Manual

5. Guide to System Setup

5.2. STACKING AX3210P AND AX1118SP SYSTEMS

  

Figure 5.11: KPTAX3210S – Coupling configuration
Technical Office.
5.2 Stacking AX3210P and AX1118SP systems
Stacked AXIOM Systems arrays can be created either using an AX1118P SUB directly on the ground as
a base or employing flying bar KPTAX3210 adding its feet (95AXMPDN). The coupling procedure of the
enclosures is the same followed for a suspended array, with the only difference that the array is mounted
upside down.
Incorrect use of the array stacking system can cause serious injury to persons and
damage to property.
Sound system stack rigging should be done on even, uniform, and compact surfaces. Before sound
system mounting, please carefully verify the support surface capability.
5.2.1 Stacking AX3210P systems on flying bar KPTAX3210
Choosing the array configuration
The array configuration is limited by the fact that, when stacked, the systems can only maintain partial
7
angles because only the hole on the slotted bar, and not the slot, can be used to couple them .
Flying bar KPTAX3210 used as stacking base
Flying bar KPTAX3210 with its feet 95AXMPDN can be used to stand AXIOM System Stacked Arrays
safely. As opposed to its conventional use, the bar needs to be mounted upside down on the ground
and perfectly balanced by adjusting the height of its feet. Always verify that the bearing surface is stable
and compacted.
7
When designing the system, simplicity and practicality in mounting the suspended version prevailed, and we introduced a
slotted bar to diminish the compression stress during the ascent and descent of the system
55