BENDIX EC-14 ANTILOCK CONTROLLER Manual page 20

START HERE
WHITE
WHITE
™
M-12 MODULATOR
WIRE HARNESS
CONNECTOR
RESETTING
EC-14 ™ CONTROLLER
MAGNET
HERE
20
TROUBLESHOOTING
TESTING FOR THE REAR (M-12
Turn the ignition off. Separate the EC-14
from the M-12 ™
connector between the two components and test
resistance on the modulator connector.
Black to black: ........................................ 9 to 12 Ohms
White to white: ....................................... 9 to 12 Ohms
BLACK
Is resistance in range?
BLACK Reconnect EC-14
modulator. Turn ignition on and pass magnet
over "RESET" on EC-14
remove. Note reaction of red LEDs
"Inspection for Illuminated
SECTION VII
™ ) MODULATOR
™
modulator. Disconnect the four pin
YES
™
controller to M-12
™ controller and
NO
Are any red LEDs
illuminated?
YES
YES
Are same red LEDs
illuminated?
NO
Go to Section IV
Red LEDs"
controller
NO
Replace the M-12
solenoid assembly
™
Repeat the "Initial
Start-up Procedure"
Replace EC-14
Repeat the "Initial Start-up
Procedure."
™
modulator
™
controller.