Panel Removal - Scotsman C2648 - SERVICE MANUAL 11-2010 Service Manual

C2648 Service Manual - Installation

Panel Removal

1. Locate and loosen the two screws at the front
edge of the top panel.
2. Pull the front panel out at the top until it clears
the top panel.
3. Lift the front panel up and off the machine.
4. Remove two screws from the front edge of
the top panel.
5. Lift up the front of the top panel, push it
back an inch, then lift to remove.
6. Locate and loosen the screw holding each side
panel to the base.
7. Pull the side panel forward to release it from
the back panel.
The model number on the ice machine can be
found either on the dataplate, which is on the back
panel, or the serial number tag, which is behind the
front panel. See the illustration for the locations of
the dataplate and the serial number tag.
The remote condenser has a separate model and
serial number. Its model and serial number is on
the dataplate on the condenser near the quick
connect fittings.
5
6
1
Panel Removal
Uncrate and Set Up
Begin with the ice storage bin. Uncrate and attach
legs. Check the bin top gasket for tears or gaps. If
recycling an older bin, replace the gasket or repair
with food grade sealant prior to placing the ice
machine on the bin.
Install the bin top adapter if one is required for the
application.
If the ice machine has not been unpacked, do so
now. Remove the carton from the skid. Cut away
any shipping strapping. Lift the ice machine off the
skid directly onto the bin.
Note: The machine is heavy. Use a mechanical lift.
If lifting from the front, be sure that fork tines are
under the front and back of the cabinet. If lifting
from the side, be sure to have tines under the front
and back. Do not lift on the sump bottom.
Scotsman BH1100, BH1300, BH1600: Position
back of ice machine 2 3/8" from back of bin.
Secure the ice machine to the bin with the
hardware provided (two metal Z straps and four
bolts).
November 2010
Page 7