Control Button Use (From Standby) - Scotsman C2648 - SERVICE MANUAL 11-2010 Service Manual

C2648 Service Manual

Control Button Use (from standby)

Set purge level, 1-5 (1 is minimum, 5 is maximum) or Automatic:
•
Hold off button in for 3 seconds. Release.
•
Press and release the On button to cycle through and select one of the five purge settings or to use
the Automatic setting.
Recall diagnostic code:
•
Hold off button in for 3 seconds. Release.
•
Press and release the Harvest button to cycle through each of the last 10 error codes from most
recent to oldest.
Clear diagnostic code:
•
Hold Clean and Harvest buttons in for 3 seconds to clear all prior codes.
Reset control:
•
Depress and release Off, then depress and release On
Start Test Mode:
•
Hold Off button in for 3 seconds. Release.
•
Hold Clean button in for 3 seconds. Release.
Lock / Unlock control:
•
Hold On button in for 3 seconds, keep holding then press and release Off twice.
Empty reservoir:
•
Hold Clean button in for 3 seconds. Release. Pump and purge valve will be ON for 30 seconds.
Repeat as needed.
Test Mode:
•
Depress Off for 3 seconds, release. Then depress Clean for 3 seconds.
The sump will fill the first 30 seconds of the test. If the sump is full it will overflow into the bin. At 30
seconds the WIV will shut off and the WP will turn on. You will be able to see and hear the water
running over the plates. After 10 seconds the PV and HGV will turn on. Water will be purging from the
machine. After 10 more seconds the compressor will start. 5 seconds later the HGV will close. The
compressor will run for a total of 20 seconds. After which everything will turn off for 5 seconds. After
that time the HGV will open and you'll be able to hear the hissing as the pressure is equalized. After 10
seconds all will be off and the output test will be complete.
November 2010
Page 17