Installation: Product Specifications - Scotsman C2648 - SERVICE MANUAL 11-2010 Service Manual

C2648 Service Manual - Installation

Installation: Product Specifications

Location Limitations
This ice system is made up of three parts, the ice
making machine, or head; the remote condenser;
and the interconnecting tubing. The ice making
machine must be installed indoors, in a controlled
environment. Space must be provided near the
machine for service access. The remote condenser
may be installed above or below the ice machine,
per the limits stated later in this manual. The
remote condenser may be installed outdoors within
the temperature limits listed below. The
interconnecting tubing must be installed per the
directions stated in this manual, and the amount of
tubing exposed to uncontrolled temperatures must
be minimized.
Space Limitations
Although the machine will function with no
clearance to the top and sides, some space must
be allowed for service access. Building the
machine in with no access will cause higher service
cost, in many cases this extra cost may not be
covered by warranty.
Environmental Limitations, ice machine:
Minimum
o
Air temperature 50 F.
o
Water 40 F.
temperature
Water pressure 20 psi
Note: While the ice machine will operate under the
listed conditions, ice making capacity will be
reduced with increases in water supply
temperature and/or air temperatures at the
condenser. Bin meltage will also increase with any
increase in room temperature.
Remote condenser
Air temperature -20
Power Supply
208-230 volt
model
Warranty Information
The warranty statement for this product is provided
separately from this manual. Refer to it for
applicable coverage. In general warranty covers
defects in material and workmanship. It does not
cover maintenance, corrections to installations, or
situations when the ice machine is operated in
circumstances that exceed the limitations printed
above.
Product Information
The machine is a specialized version of a modular
cuber. A modular cuber does not include any ice
storage, it is designed to be placed onto an ice
Maximum
storage bin. Many installations only require the
o
100 F.
matching bin, but some may need an adapter to be
o placed between the ice machine and the bin.
100 F.
Additionally, the machine must be connected to the
correct remote condenser and use the correct
80 psi
pre-charged tubing. The machine is supplied with a
full refrigerant charge, field charging is not
required.
This product cannot be stacked.
November 2010
Page 2
Minimum Maximum
o o
F. 120 F.
Minimum Maximum
198 volts 253 volts