support.dell.com
To enter an IP address, perform the following steps:
1.
Use <Up> and <Down> to increase or decrease the displayed value. The under-
lined cursor indicates the numbers to modify.
2.
After entering a number, press <Tab> to move the cursor to modify the next field.
3.
After setting the Fibre Channel's IP address, press <Enter> to store the value.
Pressing <Enter> while Fibre Channel Subnetmask is selected displays the Fibre
Channel's subnet mask address.
The default subnet mask value is none. Consult your network administrator for the
appropriate subnet mask
Enter the switch's Fibre Channel Subnetmask by using <Up> and <Down> to
increase or decrease the displayed value.
!
"
Pressing <Enter> while Gateway address is selected displays the fibre channel's
gateway address.
The default gateway address is
required.
To enter a gateway address, perform the following steps:
1.
Use <Up> and <Down> to increase or decrease the displayed value. The under-
lined cursor indicates the numbers to modify.
2.
After entering a number, press <Tab> to move the cursor to modify the next field.
3.
After setting the Fibre Channel's IP address, press <Enter> to store the value.
#
The domain number uniquely identifies the switch in a fabric. This switch ID is nor-
mally automatically assigned by the switch and may be any value between 1 and 239.
If VC-Encoded Address Mode is in effect, then the values are between 0 and 31. You
may also assign this number manually.
$
Pressing <Enter> while BB_credit is selected displays the number of buffers available
to the host.
Managing the PowerVault 56F 16-Port Fibre Channel Switch
. You must enter a valid gateway address, if
3-9