Dell PowerVault 50F Installation And Troubleshooting Manual page 28

1-4 Installation and Troubleshooting Guide

 
   
Long-wave Duplex SC plug
laser (LWL)
connectors
Fiber Optic
Single mode fiber
9 m core diameter
125 m cladding diam-
eter duplex cable
Copper Impedance controlled
for 150-ohm differen-
tial systems
Low skew, shielded-
quad, 150-ohm cable
Polarized interface
HSSDC receptacle
Various lengths of copper and shortwave optical cables are available from Dell. These
cables have been designed and approved by Dell. Dell recommends the use of these
cables to ensure the proper operation of the switch.
Fiber cable connections are made to the switch's front panel using standard dual SC
plug connectors as shown in Figure 1-2.
The connectors are indexed and must be inserted into the GBIC module's connector
in proper alignment. In most cases, one of the two connector plugs is a different color
to aid in proper connector alignment.


 

10 kilo-meters
(32,820 feet)
12 m
(38 feet)


1270-1350 m
without open
fiber control
(non-OFC)
SCA2
printed cir-
cuit board
(PCB)
interface
HSSDC
input/output
(I/O)