Dell DR4000 Administrator's Manual page 98

FILE LOCATION: C:\Users\bruce_wylie\Desktop\Dell
Docs\~Sidewinder_Docs_DR4000\FRAME_Conversion_DR4000_AdminGuide\~DR4000_AG_F
Table 8-1. DR4000 System Alert and Event Messages
Type/Number Alert/Event Message
2170636 Configuration Service has failed
to start.
2170637 Unsupported RAID configuration
detected.
2170638 No fault tolerant RAID
configuration found.
2170639 Data volume is not present. Please
check that all disks are inserted
and powered-up.
2170640 Unable to detect filesystem type
on data volume.
2170641 A non-certified disk drive was
detected. This disk needs to be
replaced for the system to become
operational.
2170642 NVRAM has not been detected.
2170643 Invalid or unsupported Network
Configuration has been detected.
D E L L C O N F I D E N T I A L – P R E L I M I N A R Y 1 / 1 0 / 1 2 - F O R P R O O F O N LY
90
Troubleshooting and Maintenance
Description/Meaning or Action
Contact Dell Support for
assistance or intervention.
Contact Dell Support for
assistance or intervention.
Contact Dell Support for
assistance or intervention.
Verify that all of the DR4000
system disks are installed and
powered up.
DR4000 system did not
initialize properly. Contact Dell
Support for assistance or
intervention.
A non-Dell physical disk drive
was detected by the DR4000
system, which does not support
non-Dell disks. Remove and
replace the non-Dell disk with a
Dell-approved disk to allow
DR4000 system operations.
Verify that the NVRAM card is
seated properly in the DR4000
system appliance.
Use the DR4000 system CLI to
reconfigure the NICs.
For more information, see the
Dell DR4000 System
Command Line Reference
Guide
.